Search found 7 matches
- Wed Feb 22, 2012 7:10 am
- Forum: Tracking Tools
- Topic: uncorrect output values from tracking tool
- Replies: 3
- Views: 3310
Re: uncorrect output values from tracking tool
I have the same problem in exactly the same scenario: Rotating with a turntable in azimuth (Yaw).
- Wed Feb 22, 2012 6:00 am
- Forum: General OptiTrack Support
- Topic: one camera losing calibration
- Replies: 12
- Views: 10229
Re: one camera losing calibration
<t>Sorry for the delay. As far as I know all our gear is on the same power line which is old (220V 10A). The gear consists of two computers, audio interfaces, a teleo processor with two small motors and the hubs. I've been using the system just taking into account this issue and it worked relatively...
- Wed Jan 11, 2012 6:54 am
- Forum: General OptiTrack Support
- Topic: one camera losing calibration
- Replies: 12
- Views: 10229
Re: one camera losing calibration
<t>I switched the hubs and it seems to be better, at least it keeps working for longer time (but sometimes the software does not recognize both hubs but the cameras are there). However, if I connect whatever device to the electrical network, the Tracking Tools loses the cameras (all of them shift to...
- Fri Dec 23, 2011 5:08 am
- Forum: General OptiTrack Support
- Topic: one camera losing calibration
- Replies: 12
- Views: 10229
Re: one camera losing calibration
<t>When I start Tracking Tools everything seems to work fine. After a long while (around an hour or two), one of the hubs (always the same hub) seems to be lost since the cameras connected to it appears at the center of the perspective view (like before doing the ground plane setup) but keeping thei...
- Mon Dec 19, 2011 5:23 am
- Forum: General OptiTrack Support
- Topic: one camera losing calibration
- Replies: 12
- Views: 10229
Re: one camera losing calibration
<t>With only one hub will be impossible just because where the cameras are (too much distance between). I'll check the sync, maybe the wire has some problem. Thanks for the idea. On the other hand I could change the hub since we have another system around.<br/> And yes, the software crashes very oft...
- Fri Dec 16, 2011 4:52 am
- Forum: General OptiTrack Support
- Topic: one camera losing calibration
- Replies: 12
- Views: 10229
Re: one camera losing calibration
<t>Every morning during the last two weeks that camera (or the software that process the images of that camera) do not recognize any point as part of the rigid body, so I calibrated the system again every time. This last time it seems to be almost right (still is not on the center of the reflector b...
- Wed Nov 30, 2011 1:50 am
- Forum: General OptiTrack Support
- Topic: one camera losing calibration
- Replies: 12
- Views: 10229
one camera losing calibration
<t>Hi,<br/> I've been suffering a special problem. We are using an Optitrack system with 6 cameras VR100:R2 with wide lens, 2 USB Opti-Hubs (3 cameras per hub), and 2 and 1 active USB extensions per hub. The software is Tracking Tools 2.3.0. The problem is that after calibrating the system, I test t...