Thanks @Urbanolu for those settings. I'm using an AMTI OR6-7 series force plate and have purchased an esync to be used with a bank of s250e cameras. In Arena (v.1.800) I seem to keep getting an error message (see attached picture). Any chance you have seen that before?
Search found 3 matches
Search found 3 matches • Page 1 of 1
Hi Natural Point, I was hoping to use our motion capture system (cameras s250e) for biomechanical purposes and was wondering if there was a difference in Optihub 2 or eSync for synchronizing analog signals from two force platforms? Each of our AMTI force platforms require 6 BNC inputs OR a USB sync ...
- Wed Feb 12, 2014 3:27 pm
- Forum: General OptiTrack Support
- Topic: Optitrak and Gears?
- Replies: 1
- Views: 1160
Hi Natural Point, I had a few general questions. I have an 10 camera s250e setup and running currently with Arena. Does the system support the new GEARS software? Can the GEARS software, club calibration tool and suits be purchased without cameras? If that is possible (to use GEARS on already purcha...