forums.naturalpoint.com

If anybody is interested I tinkered a bit more with the Motive and my application while watching the packets on the Wireshark. I am sending empty NAT_CONNECT message followed by NAT_REQUEST message (with "TestRequest" message) and then waiting for the Response. All this on data port 1510. ...

Hello. For some time I am trying to obtain Motive Tracker position data on a remote device. But for some reason I cannot receive the packets when switching to Unicast mode in Motive Streaming Pane. I have a C++ program on Unix machine that can receive position packets from Motive in multicast mode, ...

Hello. I am trying to modify the pivot point of previously created rigid body so that this pivot point corresponds to the centroid of the flight controller of the UAV to which the markers are attached to. As I understand Motive positions the pivot point in the center of the space created by the mark...

Hello. I am installing an Optitrack system, which consists of 8 Flex13 cameras in a space of 6 by 6 m and height of 3.6 m. The planed use for the system is to get the position of UAV while in flight. I have installed the cameras at the corners of the space and the mid points of the sides, all at the...

Hello Steven.

Thank you for the swift response.

It was as you said, the Calibration square was not visible because I had switched tracking mode to Active, while tinkering and not knowing what it means. A soon as I switched it back to Passive tracking I could successfully calibrate the ground plane.

Hello. I have a problem, where After calibration I cannot level the ground plane because no Markers are visible in perspective view. At the same time the calibration triangle is visible in every individual camera view. I have tried calibrating and recalibrating (Wanding), resetting application setti...