TIR3 Camera not detecting anything
Posted: Thu Aug 18, 2016 1:43 pm
Have installed this after a long absence, and its been store carefully.
The led's light, and the software sees the device.
Software status says camera detected and connected.
Red lights glowing.
the device (TIR3 #29791).
software is 5.4.2.7542.
tested on windows 7 ultimate SP1, 64bit and on windows 10, 64bit..
Tried it in two different USB2.0 and one sub 3.0 ports.
Using the hat clip, and this is selected.
Restarted several times, and on one occasion, i see the reflector spots, but , but they are stuck in a fixed position. Also the switch to turn off the led's does not work (not sure if this is a TIR3 feature though). Any advise welcome.
Oh, and the vector is not active (have requested support on this).
Regards,
Gerry (fish) Abbott.
The led's light, and the software sees the device.
Software status says camera detected and connected.
Red lights glowing.
the device (TIR3 #29791).
software is 5.4.2.7542.
tested on windows 7 ultimate SP1, 64bit and on windows 10, 64bit..
Tried it in two different USB2.0 and one sub 3.0 ports.
Using the hat clip, and this is selected.
Restarted several times, and on one occasion, i see the reflector spots, but , but they are stuck in a fixed position. Also the switch to turn off the led's does not work (not sure if this is a TIR3 feature though). Any advise welcome.
Oh, and the vector is not active (have requested support on this).
Regards,
Gerry (fish) Abbott.