Extending the Y axis
Posted: Fri Feb 18, 2005 11:19 am
I would like to extend the y axis (up and down)
so that the up from zero has more travel and the down from zero can be less. I find that I have the flip over if I go too far in the up.
Is this done in the software? I have looked at the profiles some, but I am not sure as to where and what to change.
I only use the IR for flight sims and want to get the up distance to be a little greater with less head movement.
Any help is greatly appreciated.
[ February 18, 2005, 06:20 PM: Message edited by: StevenE ]
so that the up from zero has more travel and the down from zero can be less. I find that I have the flip over if I go too far in the up.
Is this done in the software? I have looked at the profiles some, but I am not sure as to where and what to change.
I only use the IR for flight sims and want to get the up distance to be a little greater with less head movement.
Any help is greatly appreciated.
[ February 18, 2005, 06:20 PM: Message edited by: StevenE ]