Vector just not working
Posted: Sat Oct 15, 2005 12:38 pm
My dot mode with the track hat (and no vector)works great. When I use the vector clip in dot mode the 2 lower dots are white and the upper dot is green. Pitch does not seem to work well but yaw does fine. When I go to vector mode the damn program goes crazy. If I yaw my head, the on screen head rotates in several different direction.
I used to use the vector function several months ago before I moved to Alaska. Worked fine then with the older software and really until BOB came out I had no need to used the vector clip.
I have been using TIR since day one (TIR1) so I have re-installed drivers, I am using latest software .27, adjusted the light filters, adjusted the dot size, I am exactly 28 inches from my unit. I have covered the center hat dot so I have no jerking around. The track window shows that I have a good signal on all 3 dots.
I am at a loss, any suggestions?
[ October 15, 2005, 07:45 PM: Message edited by: tkairshows ]
I used to use the vector function several months ago before I moved to Alaska. Worked fine then with the older software and really until BOB came out I had no need to used the vector clip.
I have been using TIR since day one (TIR1) so I have re-installed drivers, I am using latest software .27, adjusted the light filters, adjusted the dot size, I am exactly 28 inches from my unit. I have covered the center hat dot so I have no jerking around. The track window shows that I have a good signal on all 3 dots.
I am at a loss, any suggestions?
[ October 15, 2005, 07:45 PM: Message edited by: tkairshows ]