Page 1 of 1
Posted: Tue Mar 22, 2016 4:25 am
I thought I read somewhere that the smartnav 4 could be mounted using a standard camera type screw fitting. Is this correct?
If so how do you do this?
Posted: Wed Mar 23, 2016 10:26 am
Yes, if you remove the base there is a 6/32 thread mount. That is the standard for cameras and can be mounted on most new camera mounts.
Posted: Wed Mar 23, 2016 11:25 am
Thanks for confirming that.
I tried to remove the base but could not seem to do it. Is there a spring clip to take out first, or do you just pull?
Posted: Wed Mar 23, 2016 3:34 pm
There should be a metal pin that you pull out of the back. Once pulled out it releases the base.
Posted: Tue Apr 12, 2016 5:51 am
Can you give me a clue please - I am sure it is easy when you know how - but I cannot get the mount off the camera!!
I have attached pic of smartnav. Thanks
Posted: Tue Apr 12, 2016 12:00 pm
See the little metal clip in the recessed section, just under where it says Aspire? Use a hook to pull that out and it will release the base.