Status LED in pause mode
Status LED in pause mode
If I press the pause key, the SmartNave status LED turns red. But if I leave the SmartNav in pause mode for a while, the LED turns green again even though the SmartNav is still in pause mode. I am running the SmartNAV software version 3.20.008.
Re: Status LED in pause mode
Hello Eric,
I need to get a little clarification from you.
When the status LED changed, did the cursor start moving again as well?
Also, did you happen to notice how long it took for the LED to change?
[ September 07, 2004, 02:13 PM: Message edited by: Donald Forbes ]
I need to get a little clarification from you.
When the status LED changed, did the cursor start moving again as well?
Also, did you happen to notice how long it took for the LED to change?
[ September 07, 2004, 02:13 PM: Message edited by: Donald Forbes ]
Re: Status LED in pause mode
When the LED turned green on its own, the cursor did not move with the dot. When I pressed the pause key to exit pause mode, only then did the cursor begin tracking the dot.
The amount of time is variable.
The amount of time is variable.
Re: Status LED in pause mode
Eric, I have verified this (hard to reproduce!), we will look into it further.
[ September 21, 2004, 05:22 AM: Message edited by: Birch Zimmer ]
[ September 21, 2004, 05:22 AM: Message edited by: Birch Zimmer ]