i use natural point v.2.14 B.
Between the smooth and speed horizontal bars, the small verticle in center line turned red and now my natural point is not working. Why is that? How can i correct this? thanks
small verticle line turned red and now my nat
-
- Posts: 27
- Joined: Sun May 04, 2003 5:00 am
Re: small verticle line turned red and now my nat
Please try upgrading to the latest software (2.51) which can be found here: http://media.naturalpoint.com/software/ ... V_2_51.exe
If your problem persists please let us know.
Regards,
Kevin
If your problem persists please let us know.
Regards,
Kevin
-
- Posts: 27
- Joined: Sun May 04, 2003 5:00 am
Re: small verticle line turned red and now my nat
yea... but what does it (red) specifically mean?
Re: small verticle line turned red and now my nat
The icon between the speed and smooth scroll bars changes color based on the state of the tracking in the 2.xx SmartNAV software.
Bright green = Tracking
Dark green = Not Tracking
Red = Paused (Pause hotkey or Ability Switch was pressed, or Key Activated mode is enabled)
So, it sounds like your SmartNAV software is set to Paused. Check to make sure KeyActivated mode is not enabled, and press the Pause hotkey to toggle it on and off to see if that makes a difference.
[ December 21, 2004, 11:17 AM: Message edited by: Birch Zimmer ]
Bright green = Tracking
Dark green = Not Tracking
Red = Paused (Pause hotkey or Ability Switch was pressed, or Key Activated mode is enabled)
So, it sounds like your SmartNAV software is set to Paused. Check to make sure KeyActivated mode is not enabled, and press the Pause hotkey to toggle it on and off to see if that makes a difference.
[ December 21, 2004, 11:17 AM: Message edited by: Birch Zimmer ]