External sync in information

Post Reply
ricolab
Posts: 1
Joined: Sun Mar 17, 2013 4:39 pm

External sync in information

Post by ricolab » Sun Mar 17, 2013 4:48 pm

HI
I have an optitrack and i want to input a trigger to the optihub using external sync in.
Can someone have information about the jack plug. is it a mono? I suppose ground is near the wire and + at the extremity?
Do you think 5v and serial 200ohms resistor would be enough?

I don't want to make mistake !!!

Thanks

Cimi
Posts: 2
Joined: Fri Jun 17, 2016 12:03 pm

Re: External sync in information

Post by Cimi » Thu Feb 08, 2018 5:48 pm

Hi, Did you ever figure this out?

steven.andrews
NaturalPoint Employee
NaturalPoint Employee
Posts: 469
Joined: Mon Jan 19, 2015 11:52 am

Re: External sync in information

Post by steven.andrews » Fri Feb 09, 2018 12:29 pm

Hi Cimi,

The External Sync In and External Sync Out connectors, on the OptiHub, should be BNC.
https://en.wikipedia.org/wiki/BNC_connector

I hope this helps,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
support@optitrack.com

Post Reply