LED' Slider between 0 - 15

Post Reply
circassia
Posts: 24
Joined: Fri May 03, 2013 4:12 am

LED' Slider between 0 - 15

Post by circassia » Thu May 23, 2013 6:53 am

Hi,

Is it true that the slider is implemented to act between 0 - 15 but is working only between 0 - 1 (on / off) i tried to think of 0 - 15 as a incremental value of how bright the led's are or which regions of the led's are active?

Would be nice if you could clarify that.

thanks

circassia

NaturalPoint-Dustin
Posts: 612
Joined: Tue Mar 19, 2013 5:03 pm

Re: LED' Slider between 0 - 15

Post by NaturalPoint-Dustin » Tue May 28, 2013 4:33 pm

Hi Circassia,

I apologize for the delay in response, we had an extended holiday weekend. Could you explain this in further detail? Are you referring to the LED setting within the software? Which cameras are you using?

Best Regards,
Dustin
Technical Support Engineer
OptiTrack | TrackIR | SmartNav

NaturalPoint-Dustin
Posts: 612
Joined: Tue Mar 19, 2013 5:03 pm

Re: LED' Slider between 0 - 15

Post by NaturalPoint-Dustin » Wed May 29, 2013 2:33 pm

Hi Circassia,

If you have a long exposure, increasing the LED slider will not necessarily cause an increase in brightness of the camera image, because there is not enough power available to keep the IR lEDs on for that long. At short exposures, generally speaking you should see a brightness change in the image as you adjust the LED slider. If you always want the maximum available IR power, the LED slider should be set to 15.

Best Regards,
Dustin
Technical Support Engineer
OptiTrack | TrackIR | SmartNav

Post Reply