Hello everyone,
I want to know the error in location of my experiment,so i am trying to re-view the calibration results report that appeared right after calibration but i could not figgure out how to do it, and could not find any information about it online.
I will be greatful for some assistance on the matter.
Re-viewing calibration results report
-
- NaturalPoint Employee
- Posts: 720
- Joined: Mon Jan 19, 2015 11:52 am
Re: Re-viewing calibration results report
Hello ataib,
Thank you for reaching out to the community regarding your question.
It is not possible to bring up the full report that is displayed after a calibration, but it is possible to view the calibration results. If you select a Take in the Project Pane, and view its properties below the Take list, you will see that the calibration information is contained in the Take's data.
If you want to see the entire calibration again, you can run an offline calibration with the Take that is automatically recorded during the wand wave. This will allow you to review the calibration results again.
http://wiki.optitrack.com/index.php?tit ... alibration
Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
Thank you for reaching out to the community regarding your question.
It is not possible to bring up the full report that is displayed after a calibration, but it is possible to view the calibration results. If you select a Take in the Project Pane, and view its properties below the Take list, you will see that the calibration information is contained in the Take's data.
If you want to see the entire calibration again, you can run an offline calibration with the Take that is automatically recorded during the wand wave. This will allow you to review the calibration results again.
http://wiki.optitrack.com/index.php?tit ... alibration
Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
- Attachments
-
- Take Data
- Capture.JPG (17.03 KiB) Viewed 2315 times