Re-viewing calibration results report

Post Reply
ataib
Posts: 1
Joined: Thu Sep 29, 2016 1:40 am

Re-viewing calibration results report

Post by ataib »

Hello everyone,
I want to know the error in location of my experiment,so i am trying to re-view the calibration results report that appeared right after calibration but i could not figgure out how to do it, and could not find any information about it online.
I will be greatful for some assistance on the matter.
steven.andrews
NaturalPoint Employee
NaturalPoint Employee
Posts: 737
Joined: Mon Jan 19, 2015 11:52 am

Re: Re-viewing calibration results report

Post by steven.andrews »

Hello ataib,

Thank you for reaching out to the community regarding your question.

It is not possible to bring up the full report that is displayed after a calibration, but it is possible to view the calibration results. If you select a Take in the Project Pane, and view its properties below the Take list, you will see that the calibration information is contained in the Take's data.

If you want to see the entire calibration again, you can run an offline calibration with the Take that is automatically recorded during the wand wave. This will allow you to review the calibration results again.
http://wiki.optitrack.com/index.php?tit ... alibration

Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
Attachments
Take Data
Take Data
Capture.JPG (17.03 KiB) Viewed 2312 times
Post Reply