Hi all,
I am using a V120 3D camera for capturing trajectories of a roller skater on a treadmill. I defined 5 rigid bodies: a coordinate system, 2 roller skates and 2 poles, which contain 3-4 markers. Unfortunately the rigid bodies keep on vanishing during recording. Do you have any suggestions how to improve the recording?
All the markers are faced towards the camera and should be in the visible area of the camera.
The place where the recordings are taken is quite bright.
I used half sphere markers.
The skates have an extra cross shaped construction mounted on the back side for attachment of the markers.
Thank you for helping and best regards,
.....................................
Hi-Lo Industrial Trucks Co.
increase marker visibility
-
- Posts: 1
- Joined: Mon May 17, 2021 10:52 am
increase marker visibility
Last edited by nillwatson532 on Tue Sep 21, 2021 10:14 am, edited 1 time in total.
-
- NaturalPoint Employee
- Posts: 720
- Joined: Mon Jan 19, 2015 11:52 am
Re: increase marker visibility
Hi nillwatson532,
Thanks for reaching out to the community regarding your tracking results.
It is hard to say what could be happening without seeing the data. If you would like some help troubleshooting, please feel free to reach out to our support team, directly, and to provide one of your recordings (.tak)
Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
wiki.optitrack.com
support@optitrack.com
Thanks for reaching out to the community regarding your tracking results.
It is hard to say what could be happening without seeing the data. If you would like some help troubleshooting, please feel free to reach out to our support team, directly, and to provide one of your recordings (.tak)
Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
wiki.optitrack.com
support@optitrack.com