Driver install for the new SDK
Driver install for the new SDK
I am having troubles recognizing the Optitrack Flex C120 on my laptop. The manual driver installation says "The specified location does not contain information about your hardware" when pointed to npusb3.inf. It does however work fine on my desktop, but I need the laptop to present my project.
Any ideas about how I can get this working? I know its a very simple problem, but after searching through the forums, I couldn't find a solution.
Any ideas about how I can get this working? I know its a very simple problem, but after searching through the forums, I couldn't find a solution.
Re: Driver install for the new SDK
What chipset are you using on the laptop?
Do you have the latest motherboard bios for the system?
Have you tried a self-powered USB hub?
Do you have the latest motherboard bios for the system?
Have you tried a self-powered USB hub?
Re: Driver install for the new SDK
It doesn't work on my desktop either. "USB device not recognized" all the time.
I have sent an email to support, hopefully there will be a solution soon.
I have sent an email to support, hopefully there will be a solution soon.
Re: Driver install for the new SDK
Answered in email
Re: Driver install for the new SDK
I followed your instructions, and tried on other Windows desktops in our lab, but still bad luck. Please see the replied email for detail.
thanks.
thanks.
Re: Driver install for the new SDK
Could you resend your email, as I do not seem to have a copy.
Re: Driver install for the new SDK
I resent it.
BTW, we are using desktops.
BTW, we are using desktops.
Re: Driver install for the new SDK
Answered in email...
Re: Driver install for the new SDK
Turned out that my problem was that I had the previous Optitrack drivers loaded before, and then the new ones on top. I was not able to remove the drivers and registry settings off this hard drive, so I had to format my laptop. After that it worked fine.
Re: Driver install for the new SDK
OK, thanks for the input.....