Page 1 of 1
TCP broke at joint... suggestions?
Posted: Tue Dec 09, 2014 1:05 pm
by ryanbatc
My TCP broke at this point... the little "grabber" feet snapped off (one side did) - anyone have an idea on how to mend this connection but keep the swivel function intact?
Re: TCP broke at joint... suggestions?
Posted: Wed Dec 10, 2014 1:12 pm
by MikeWitham
Hello ryanbatc,
I'm sorry to see that it has broken at the joint. I don't know of any way to repair it and keep the swivel function. Would you please create a ticket with me at help.naturalpoint.com so I can see if there is anything I can do to help you out?
Regards,
Re: TCP broke at joint... suggestions?
Posted: Sun Jan 11, 2015 8:54 am
by Jwhal
- my fix.JPG (91.36 KiB) Viewed 5915 times
Mine broke in a couple places this is what I used to mend it but you loose movement in the joints.
Re: TCP broke at joint... suggestions?
Posted: Sun Jan 11, 2015 8:58 am
by Jwhal
This is how I fixed mine broke in two places.
You loose the movement of the joints.
- My fix
- my fix.JPG (91.36 KiB) Viewed 5915 times
Re: TCP broke at joint... suggestions?
Posted: Mon Jan 12, 2015 5:22 pm
by MikeWitham
Jwhal,
Thank you for posting your solution. QuikSteel is a pretty solid solution!
Regards,
Re: TCP broke at joint... suggestions?
Posted: Tue Jan 20, 2015 8:43 pm
by ryanbatc
Sorry for now following up
I just used some painter's tape to hold it in place. That epoxy looks to be a more permanent
idea hehe