Page 2 of 2

Re: DIY Project

Posted: Tue Oct 11, 2011 4:53 am
by AndyT
Just to resurect this old-ish thread. I now have a TIR5 and Trackclip Pro. I also hate the wire, so have bought this from eBay:

http://www.ebay.co.uk/itm/120772528271? ... 125wt_1064

Holds 2 x AAA batteries, built in switch and I'll simply attach it to the top of my wireless headset, a creative HS-1200.

I will change the resistor in the clip (underneath the rubber in the clip) to an appropriate value to take into account the lower voltage (2.4v as opposed to 5v). The AAA's are rechargeable thats why they're 1.2v each not 1.5v.

I'll take some pics and post on here when it's done :)

Re: DIY Project

Posted: Wed Oct 12, 2011 5:15 pm
by NaturalPoint - Mike
Be careful on that resistor swap, I've burnt out my share of LEDs before.

Re: DIY Project

Posted: Mon Oct 17, 2011 11:26 am
by AndyT

Re: DIY Project

Posted: Fri Oct 21, 2011 6:51 pm
by MaddHatter
great job. having the battery pack on the opposite side must balance it out quite nicely.