I just noticed that the distances reported by Tracking Tools are not in millimetres as I expected, but are instead doubled. For example, the real distances between markers on the calibration square (found using a tape measure) are as follows:
Origin to end of X axis: 300mm
Origin to end of Z axis: 400mm
End of X axis to end of Z axis (diagonally): 500mm
However, the coordinates of the markers reported by Tracking Tools result in the following measurements:
Origin to end of X axis: 600mm
Origin to end of Z axis: 800mm
End of X axis to end of Z axis (diagonally): 1000mm
These measurements are out by double the distance. Is there any reason for this? It seems like an arbitrary scaling that isnï¿½t useful. Iï¿½m currently having to halve all of the measurements I obtain using Tracking Tools because of this.
Is there any way I can force Tracking Tools to return the true real-world distances?
1 post • Page 1 of 1