TrackIR Pro Clip setup

Post Reply
Soko
Posts: 3
Joined: Tue Sep 17, 2019 7:57 pm

TrackIR Pro Clip setup

Post by Soko » Tue Sep 17, 2019 8:04 pm

So I just got this and have been trying to set it up. I managed to get the regular clip on the hat work just fine looking in all quadrants. However, when I try to setup the ProClip, it does not turn left, instead when I turn left It locks on the 0 axis and starts tracking upwards. Why is there no simple. Put it on.. turn left, turn right, look up, look down, calibration feature?

Chris.Johnson
NaturalPoint Employee
NaturalPoint Employee
Posts: 107
Joined: Tue Aug 15, 2017 1:56 pm

Re: TrackIR Pro Clip setup

Post by Chris.Johnson » Wed Sep 18, 2019 10:04 am

Hello Soko,

Did you change the tracking device from TrackClip, to TrackClipPro?
All the Best,
Chris Johnson
Customer Support Engineer
NaturalPoint

Soko
Posts: 3
Joined: Tue Sep 17, 2019 7:57 pm

Re: TrackIR Pro Clip setup

Post by Soko » Wed Sep 18, 2019 2:52 pm

Thanx for the quick reply. Yeah I selected it, would hit reset to center it. Works fine to the right but the left is not registering. Going to make sure the clip is not upside down when I get home.

Soko
Posts: 3
Joined: Tue Sep 17, 2019 7:57 pm

Re: TrackIR Pro Clip setup

Post by Soko » Wed Sep 18, 2019 4:29 pm

so turns out I had the probes upside down.. twisted it around and it's recognizing all quadrants like the clip for the hat.

Post Reply