Trying to figure how to adjust the curve to increase the dead zone. I like the default profile but don't want to use the default hot keys. I've created my own profile and adjusted the curve to look like the default curve but my dead zone doesn't match the default.
What do I have to do to increase my dead zone?
Jim
Increasing Dead Zone
Re: Increasing Dead Zone
Just move the dots horizontally out from center I would think.
-
- Posts: 1477
- Joined: Mon Nov 04, 2013 10:19 am
Re: Increasing Dead Zone
JimAllen,
Duke is correct, you would move the second set of dots on your curve horizontally outward, but on the same level as your center dot.
You could also just load the default profile, and then click the copy button. It is the button that looks like two slips of paper between the template section and the add new profile button.
Regards,
Duke is correct, you would move the second set of dots on your curve horizontally outward, but on the same level as your center dot.
You could also just load the default profile, and then click the copy button. It is the button that looks like two slips of paper between the template section and the add new profile button.
Regards,
Mike Witham
TrackIR Product Manager
TrackIR Product Manager
Re: Increasing Dead Zone
Thanks for the advice. Greatly appreciated.
Jim
Jim
-
- Posts: 1477
- Joined: Mon Nov 04, 2013 10:19 am
Re: Increasing Dead Zone
Jim,
Please let me know if that works out for you.
Regards,
Please let me know if that works out for you.
Regards,
Mike Witham
TrackIR Product Manager
TrackIR Product Manager