Avoid movement when the head is slowing down

Post Reply
umbrellaman
Posts: 1
Joined: Sat Feb 03, 2018 4:20 pm

Avoid movement when the head is slowing down

Post by umbrellaman »

Hello,
I use trackir5 with a P3D airbus 320, so basically, a cockpit with a dense concentration of buttons and screens which are located further from the pilot than in a jetfighter.

Here is the problem: to reach the last switches on the upper overhead panel and pedestal panel I need to rotate my head a lot, making very difficult both to see and to stabilize the view (so almost impossible to clic on the smallest switches).

Yes I could lift the yaw and pitch curves in the software but I would result in a too sensitive tracking.
I'm looking for a solution to make the view completely stable when I try to stabilize my head.

So my question is: how to decrease the tracking sensitivity when the head is very slow.

:)
Chris.Johnson
Posts: 139
Joined: Tue Aug 15, 2017 1:56 pm

Re: Avoid movement when the head is slowing down

Post by Chris.Johnson »

Hello umbrellaman,

First I would try and adjust the Yaw and Pitch controls in the graphs as you mentioned, then reduce the speed of the motion control in basic settings to .5 and see how that works.
All the Best,
Chris Johnson
Customer Support Engineer
NaturalPoint
Post Reply