Page 1 of 1
TrackIR Pro Clip setup
Posted: Tue Sep 17, 2019 8:04 pm
by Soko
So I just got this and have been trying to set it up. I managed to get the regular clip on the hat work just fine looking in all quadrants. However, when I try to setup the ProClip, it does not turn left, instead when I turn left It locks on the 0 axis and starts tracking upwards. Why is there no simple. Put it on.. turn left, turn right, look up, look down, calibration feature?
Re: TrackIR Pro Clip setup
Posted: Wed Sep 18, 2019 10:04 am
by Chris.Johnson
Hello Soko,
Did you change the tracking device from TrackClip, to TrackClipPro?
Re: TrackIR Pro Clip setup
Posted: Wed Sep 18, 2019 2:52 pm
by Soko
Thanx for the quick reply. Yeah I selected it, would hit reset to center it. Works fine to the right but the left is not registering. Going to make sure the clip is not upside down when I get home.
Re: TrackIR Pro Clip setup
Posted: Wed Sep 18, 2019 4:29 pm
by Soko
so turns out I had the probes upside down.. twisted it around and it's recognizing all quadrants like the clip for the hat.