Adjust clip position relative head
Posted: Tue Dec 03, 2019 12:33 pm
Hi!
Just got my TrackIR 5 and I love it. But I would like to adjust a setting which I can't find, perhaps it is in an ini file? I use the "cap-clip" but attached to my headset. This means that the clip is further back from the monitor in relation to the centre of rotation of my head than the software expects. This causes the camera to bob up and down as I tilt my head up and down. So I need to adjust the Z-position of the clip relative rotation centre.
Attempt at ascii illustration (c is clip, lines my head)
Default:
__ c
/ \
My config:
_c
/ \
Just got my TrackIR 5 and I love it. But I would like to adjust a setting which I can't find, perhaps it is in an ini file? I use the "cap-clip" but attached to my headset. This means that the clip is further back from the monitor in relation to the centre of rotation of my head than the software expects. This causes the camera to bob up and down as I tilt my head up and down. So I need to adjust the Z-position of the clip relative rotation centre.
Attempt at ascii illustration (c is clip, lines my head)
Default:
__ c
/ \
My config:
_c
/ \