Hi,
We would like to feed the E-Sync module with an external signal to sync cameras. Which input can be used voltage wise if our sync signal is on a RS-232 cable ?
Thanks,
Remi
E-Sync external sync signal type
-
- Posts: 609
- Joined: Tue Mar 19, 2013 5:03 pm
Re: E-Sync external sync signal type
Hi Remi,
Thank you for posting. Do you know the voltage of the source of the signal?
Best Regards,
Thank you for posting. Do you know the voltage of the source of the signal?
Best Regards,
Dustin
Technical Support Engineer
OptiTrack | TrackIR | SmartNav
Technical Support Engineer
OptiTrack | TrackIR | SmartNav
Re: E-Sync external sync signal type
it is RS-232, so I think it is -12 V to +12 V.
Re: E-Sync external sync signal type
any suggestion ?
-
- Posts: 609
- Joined: Tue Mar 19, 2013 5:03 pm
Re: E-Sync external sync signal type
Hi Sanscart,
I am researching this for you right now. I will have an answer for you shortly.
Best Regards,
I am researching this for you right now. I will have an answer for you shortly.
Best Regards,
Dustin
Technical Support Engineer
OptiTrack | TrackIR | SmartNav
Technical Support Engineer
OptiTrack | TrackIR | SmartNav
-
- Posts: 609
- Joined: Tue Mar 19, 2013 5:03 pm
Re: E-Sync external sync signal type
Dear Sanscart,
The RS232 spec also allows voltages higher than this. We recommend measuring the voltage of the signal on a scope to be safe.
Our recommended approach would be to run their RS232 signal into a RS232 level shifter, and connect the output of the level shifter to the Isolated input of the eSync.
Best Regards,
The RS232 spec also allows voltages higher than this. We recommend measuring the voltage of the signal on a scope to be safe.
Our recommended approach would be to run their RS232 signal into a RS232 level shifter, and connect the output of the level shifter to the Isolated input of the eSync.
Best Regards,
Dustin
Technical Support Engineer
OptiTrack | TrackIR | SmartNav
Technical Support Engineer
OptiTrack | TrackIR | SmartNav