forums.naturalpoint.com

Hi Natural Point,

I was hoping to use our motion capture system (cameras s250e) for biomechanical purposes and was wondering if there was a difference in Optihub 2 or eSync for synchronizing analog signals from two force platforms? Each of our AMTI force platforms require 6 BNC inputs OR a USB sync (1 for each platform).

If there is anyone part of the community that has done this as well any guidance will be appreciated!

Thanks for your support!

Hello,

Thank you for posting on the forums. You would need to use the eSync with your S250e camera system. OptiHub 2 is used with the Flex 13, V100 or V100:R2 cameras.

Regards,