Following along the steps here:
https://v21.wiki.optitrack.com/index.ph ... _Markerset
Setup the Chest, the Hmd checked names etc. Got my perfomer to Tpose I get to s Step 6: Create Rigid Body Skeleton. It says 'select the two rigid bodies and press Create on the Skeleton pane.'
Assuming the Skeleton pane is the one in the pic below, which is called 'builder'; in my Motive:Body I hit create and Motive says:
Create Skeleton
Unable to find skeleton markers
What am i doing wrong? I have tried combinations of the Enable Marker/RigidBody/Skeleton selection buttons in the Perspective view
'Unable to find Skeleton' Markers 6 Rigidbody
-
- Posts: 41
- Joined: Fri Aug 17, 2018 11:15 am
- Contact:
-
- NaturalPoint Employee
- Posts: 737
- Joined: Mon Jan 19, 2015 11:52 am
Re: 'Unable to find Skeleton' Markers 6 Rigidbody
Hello BrunoMartelli,
Thanks for reaching out to the community regarding your skeleton creation troubles.
It is hard to say what could be happening without seeing the data.
Would you be able to send a recording (.tak) of the T-Pose to our support team? This would allow us to do some testing on our end.
Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
support@optitrack.com
Thanks for reaching out to the community regarding your skeleton creation troubles.
It is hard to say what could be happening without seeing the data.
Would you be able to send a recording (.tak) of the T-Pose to our support team? This would allow us to do some testing on our end.
Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
support@optitrack.com
-
- Posts: 41
- Joined: Fri Aug 17, 2018 11:15 am
- Contact:
Re: 'Unable to find Skeleton' Markers 6 Rigidbody
Hi sure doing it now
Re: 'Unable to find Skeleton' Markers 6 Rigidbody
Hello,
Did you manage to solve this problem in the end? If you did, could you kindly please share the solution?
Having a similar problem now, I googled around and bumped into your question here.
Best,
tmishina
Did you manage to solve this problem in the end? If you did, could you kindly please share the solution?
Having a similar problem now, I googled around and bumped into your question here.
Best,
tmishina