Dear,
I am using Motive 2.3.0 (in Windows 10).
Would it be possible to export the initial time of a capture (consistent with the Windows clock)?
Since I am using it to do captures together with other systems (using the same PC), this would be good to synchronize the data a posteriori, avoiding the use of a cable to send a trigger.
If the information of the initial time can be exported for example to the csv would be nice. However, I could not find this option. Is this possible in Motive 2.3.0?
Thank you very much.
Best regards,
Gil Serrancolí
Export initial time
-
- NaturalPoint Employee
- Posts: 720
- Joined: Mon Jan 19, 2015 11:52 am
Re: Export initial time
Hello Gil,
Thank you for sharing your question with the community.
When you export a CSV file the header will include the Capture Start Time. This is the system time from when the recording was started.
I hope this helps,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
wiki.optitrack.com
support@optitrack.com
Thank you for sharing your question with the community.
When you export a CSV file the header will include the Capture Start Time. This is the system time from when the recording was started.
I hope this helps,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
wiki.optitrack.com
support@optitrack.com
-
- Posts: 1
- Joined: Wed Apr 06, 2022 7:57 pm
- Contact:
Re: Export initial time
This is the system time since the recording began.