Bug reports

Post Reply
AlphaMouse
Posts: 1
Joined: Thu Jul 07, 2022 5:49 am

Bug reports

Post by AlphaMouse » Thu Jul 07, 2022 8:34 am

Hello folks,

just letting you know there is a reproducable issue with some cameras being inactive after starting up motive 3.0.1 (in our case with 12 PrimeX 13)
Cameras which don't receive data vary every time and the bug can be resolved by altering the threshold value. (e.g. set to 201 and back to 200)

We also can confirm the dropouts mentioned in another topic, sometimes the signal from all cameras is lost for 1-2 frames.

Another phenomenon is the hyper-extension of elbows (handstand, flare or similar motions with hand+floor contact) - is there a way to restrict the motion range or a recommended setting for fine tuning/reconstruction/solving?

Hope some veterans can jump in and have a look.

All the best
AM

adamdoron
Posts: 1
Joined: Mon Nov 21, 2022 2:17 am

Re: Bug reports

Post by adamdoron » Mon Nov 21, 2022 2:21 am

Hi
I have the same issue where some cameras being inactive after starting up motive 3.0.1 (in our case with 4 PrimeX 13) Cameras.
This issue doesn't occur in all of our computers so it might be something in Motive's software requirements but we didn't figure it out yet.
Did you manage to solve it?

Thanks,
Adam

Post Reply