P3D V4 - working yesterday, not today.

Post Reply
Posts: 2
Joined: Fri Mar 29, 2019 10:24 am

P3D V4 - working yesterday, not today.

Post by BernieS » Fri Mar 29, 2019 10:33 am

As above, my brand new IR5 was working in P3D V4 yesterday, now it isn't.

Following the advice in these forums, I have re-installed simconnect, however to no avail.

It works just fine in the Track IR software, & is also performing without problems in DCS - however P3D just doesn't want to know.

I submitted a ticket to support, & received what I can only assume is an automated reply, as it is exactly the same text that I have seen in the forums, & asked several questions that I had already submitted answers to in my original email.

There have been no updates to either P3D or Windows 10 since yesterday.

Does anybody have experience of successfully overcoming this problem?

NaturalPoint Employee
NaturalPoint Employee
Posts: 139
Joined: Tue Aug 15, 2017 1:56 pm

Re: P3D V4 - working yesterday, not today.

Post by Chris.Johnson » Wed Apr 24, 2019 3:09 pm


Thank you for connecting via the forums. Track IR needs to be run first, before you launch P3D, otherwise it wont register properly. Are you launching TIR before running P3D?
All the Best,
Chris Johnson
Customer Support Engineer

Post Reply