Hi all.
I have TrackIR2, installed, and it works fine. Don't know what version of the software (how can i tell)
However when i turn off and back on my computer, the TRACKIR hardware goes missing, ie. the software cant find it. When I disconnect and re-connect then it lights into life.
Any advice...
Re-connecting after start up each time
Re: Re-connecting after start up each time
Does this happen when you turn on the system after hibernation? If so, check this thread:
http://forums.naturalpoint.com/cgi-bin/ ... 2;t=000028
This problem still exists. I've had a few e-mail exchanges with support since then, but no fix yet.
[ February 04, 2004, 01:27 AM: Message edited by: Duster ]
http://forums.naturalpoint.com/cgi-bin/ ... 2;t=000028
This problem still exists. I've had a few e-mail exchanges with support since then, but no fix yet.
[ February 04, 2004, 01:27 AM: Message edited by: Duster ]
Re: Re-connecting after start up each time
quote:Originally posted by Duster:
Does this happen when you turn on the system after hibernation? .Don't know about hibernation. but definitely a problem on start up.
EVERY TIME
Does this happen when you turn on the system after hibernation? .Don't know about hibernation. but definitely a problem on start up.
EVERY TIME