How many axes in PPJoy?

[Jabberwock]

Did anyone manage to make PPJoy to work with all six axes? My TIR shows six axes, but PPJoy joystick shows only two...

[VincentG]

Currently I believe that the PPJoy software itself only supports 2 axes.....

[Jabberwock]

Well, I got it right, finally.

It seems that I had setup the "interface type" with two axes. After that nothing I did (either with "mapping the controller" or "interface type") was able to change that.

I had to delete the whole interface type configuration and set a new one, with the proper number of axes. Then I had to repeat the configuration for the particular joystick. Only after that I was able to see all six axes working properly...

[VincentG]

OK...