Un steady view

[jsearl98]

When I steady my head, the view wanders up and down slightly around the fixed point. This makes it difficult to click-on switches etc. How do I stop this? I can see the relevant gauges wandering slightly when I go into edit but I cant seem to edit this movement out. Any ideas?

[VincentG]

You can do this several ways -

1 - Setup a deadzone, within the profiles so that it takes a larger movement before the view is affected.

2 - Some customers pause the software, before they adjust knobs, switches, etc.

[jsearl98]

Thanks. I will try both strategies and get back.

[VincentG]

OK.......