Why I only see top half

[Flog]

When calibrating the cameras and doing the floor calibration do I put the tool on the ground or leave up in the air?

I'm trying to set the ground plane as it appears my skelton goes too low, they don't align, my head is where the hips are supposed to be and also it really does not see my whole body.

I'm using a 6 camera system. I calibrate well except the floor calibration. I don't know where I put the calibration tool for setting the ground floor.

I think that is part of the problem

[VincentG]

The calibration square is set on the floor, in the middle of the capture volume. You can set it higher, but then you would need to adjust the height settings in the software as well.

With your initial aiming of the cameras, using the preview screen, try placing a single marker, waist heght, in the middle of the capture volume, and centering the camera views on the single marker. You can also look at rotating the cameras 90 degrees, for better tracking, in a smaller capture area.

[Flog]

got it working! Yay motioncapture.