Hello.
I 'm post-processing some data. I would like to know how to tune the trajectorization that builds the .pt3 file from the .pt2 data.
How all parameters in the point cloud window are taken into account? It seems that do not all influence the trajectorization. As an example, I did tune the "min rays" option to 15, while I only have 10 cams. It should have trajecorize nothing but I obtained as much 3D points as before (with 3 "min rays"). On the opposite, when tuning the "residual", it seems to have an effect. When raising this value, some points are removed if too close to other ones.
Thanks for any help.
Armel.