When I go to launch TrackIR I just get a small window that pops up saying 'error'. I reinstalled software 4 times even going back to older versions and still the same. I have also unplugged from USB port and although the red lights show up on clip I'm not seeing lights on the unit on top of monitor.
It is a TrackClip PRO and is about 13.5 months old. Any help is appreciated.
'Error' message
-
NaturalPoint - Mike
- Posts: 1896
- Joined: Tue Feb 01, 2011 8:41 am
- Location: Corvallis, OR
Re: 'Error' message
What type of video card do you have? If it's a Radeon, try going to the catalyst control center and turning off triple buffering.
Re: 'Error' message
That worked Mike thank you!
Re: 'Error' message
Thank you for this post. I would have been scratching my head for days on this one too.
Radeon 6950 user here, I guess Catalyst 12.3 must have turned on triple buffering by default? (edit- I swear I had 12.4 installed but CCC says 12.3. I re-installed 12.4 and it still says 12.3 for whatever its worth...)
TIR was working fine and I noticed it after I updated video drivers but I would have never guessed to disable triple buffering to fix TIR.
Highlighted below where to tick this box off in case anyone needs it.
Click here for full size image.
Thanks again!!
Radeon 6950 user here, I guess Catalyst 12.3 must have turned on triple buffering by default? (edit- I swear I had 12.4 installed but CCC says 12.3. I re-installed 12.4 and it still says 12.3 for whatever its worth...)
TIR was working fine and I noticed it after I updated video drivers but I would have never guessed to disable triple buffering to fix TIR.
Highlighted below where to tick this box off in case anyone needs it.
Click here for full size image.
Thanks again!!