forums.naturalpoint.com

Hello,

I have a new Trackir 5. It works 100%

If I use the clip on my hat, the tracking is 100%. It follows my head motion perfectly.
However, The proclip does not give the same results. If I turn my head to the side, the image tilts - usually down. Since the clip on my hat works perfectly, I can use the system with my flight simulators. I would like to know if I missed something in the setup of the PROCLIP.

Thanks in advance,
Ron Sagel

Hi Ron,

Make sure that you change the "Tracking Target" under Basic settings to TrackClip PRO. Also, make sure you offset the TrackIR 5 on your monitor when using the TCP, so it is in front of the clip (necessary since the TCP mounts on the side of your head, not the front).

- Seth

Hello,

Thank you for the help. Actually, the problem was probably a
"newbie" issue.

I did not swing the PROCLIP arm down to the bottom. Once I
did this, the TRACKIR worked fine.

Thanks,

Ron Sagel