Problems with rigid body and camera properties
Posted: Tue May 07, 2013 12:47 am
We have just upgraded from Tracking Tools to Motive. We are having the following problems with Motive:Tracker:
1) The rigid body properties tab is missing the advanced properties section as shown in the Wiki.
2) The camera calibration tab is also missing the advanced properties section. These first two problems are also raised in this thread: http://forum.naturalpoint.com/forum/ubb ... mber=55900
3) Editing the currently accessible properties of rigid bodies has no effect at all. Changing the name of a rigid body immediately reverts to the original name upon pressing enter. Changing any of the Boolean properties (e.g. the show orientation property) has no effect and reverts to its original state upon reselecting the rigid body in question.
I hope that somebody can help, since these points are crucial for my lab's use of OptiTrack and Motive.
Thanks!
1) The rigid body properties tab is missing the advanced properties section as shown in the Wiki.
2) The camera calibration tab is also missing the advanced properties section. These first two problems are also raised in this thread: http://forum.naturalpoint.com/forum/ubb ... mber=55900
3) Editing the currently accessible properties of rigid bodies has no effect at all. Changing the name of a rigid body immediately reverts to the original name upon pressing enter. Changing any of the Boolean properties (e.g. the show orientation property) has no effect and reverts to its original state upon reselecting the rigid body in question.
I hope that somebody can help, since these points are crucial for my lab's use of OptiTrack and Motive.
Thanks!