forums.naturalpoint.com

Hi,

Is it true that the slider is implemented to act between 0 - 15 but is working only between 0 - 1 (on / off) i tried to think of 0 - 15 as a incremental value of how bright the led's are or which regions of the led's are active?

Would be nice if you could clarify that.

thanks

circassia

Hi Circassia,

I apologize for the delay in response, we had an extended holiday weekend. Could you explain this in further detail? Are you referring to the LED setting within the software? Which cameras are you using?

Best Regards,

Hi Circassia,

If you have a long exposure, increasing the LED slider will not necessarily cause an increase in brightness of the camera image, because there is not enough power available to keep the IR lEDs on for that long. At short exposures, generally speaking you should see a brightness change in the image as you adjust the LED slider. If you always want the maximum available IR power, the LED slider should be set to 15.

Best Regards,