profile name incomplete

[delta_9_tetra]

Hi I'm using 2.0 on win98se.

Sometimes the name of the profile is displayed incompletely on the 'Main' page.

I created a profile called 'd9t' and it is reported as 'd9' on the Main tab - the 't' is missing.

Apparantly its miss-spells the profile name every time I open the program. Also if I load this profile from the 'Profiles' tab the name is reported incorrectly on Main.

As an experiment I deleted that profile out of the directory and created a new one called s2r, which also gets named wrongly on Main, as s2.

Perhaps its only me who will use a three character code with a number in the middle as a profile name, but there is something very minor going wrong!

Here is the contents of the profile s2r.tir

120,16,16,0,0,1,1,0,1,0,0,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.000000,20.0 00000,20.000000,20.000000,1,1,1,1,5,50,5,50,0,0,0,1,1,0,0,0,0,0,91,92,123,121,0,119,122,91,92,88,68,0,66,87,C:\Program Files\Microsoft Games\FS2002\Modules\TrackIR.dll,0,English,s2r.tir,1,,1,0,1,46,0,1,0,

[snake122]

I have this same problem and it also happens with r and i at the end of a profile. What's your system specs? Also do you have a problem with stuck hotkeys after you reprogram them?

Mine: Track IR with homemade "active dot," Cougar HOTAS, Masterpilot, PC Dash 2, eD wired 3D Glasses, ASUS TUV4X (Via chipset) with on-board audio, Celeron 1.3 ghz, 480 mb of SDRAM, Geforce4 4200, dual boot of Win2000 and Win98 with SP1 (not SE).

[ February 21, 2003, 11:23 AM: Message edited by: Snake122 ]

[delta_9_tetra]

My system specs? I think our systems are sufficiently different to point a finger at 2.0 as the culprit!

ECS K7S5A mobo (SiS 735 chipset)
AMD XP1500 @1328Mhz
512Mb pc2100 ddrram
EchoGina24 audio card
a couple of h/d's
GeForce4 Ti 4200 / 64Mb ddrram + detonator 42.30
Iiyama HM903DT 19"
win98se (updated) + directX 9.0
trackIR
CH ProPedals USB
cheap old 'joy'-stick
USB aDSL modem

On stuck hotkeys, I cannot get the switch "Motion Mode" to stay off, and apart from that I only have one hot key in use: Enable/Toggle. That is working as expected.