forums.naturalpoint.com

This was my post:
Does any tech out there know how to edit out (or is it possible to edit out) the upside down rearward view in Trackir v2.01b. I dont fly online and I like being able to look at my 6 oclock but dont like the wierd view in my setup. Any help appreciated.
I already have v2.01 final which works fine but you cannot get a true 6 oclock view which I know from experience in flying real airplanes that my neck can turn as far as the rear view in v2.01 final and by shifting my eyes I can see my 6 oclock(vertical stabilizer) so if I could get rid of the upside down view in v2.01b I feel it would be closer to real.
I didnt know this was such an issue until today. Can anyone here help me?

whurst1,

Load your profile, go to the Motion tab, click on Absolute Mode and try creating dead zones at the extremes of the Y axis by reducing the speed to zero at edit points 40 and 50. Experiment a little till the view slows down or stops before you get to the 6 o'clock position. Be sure to decouple the X-Y axes by clicking on the blue chain link in the "Edit a Motion Axis" line and choose the Y Axis. Other than that it's just a matter of limiting your up and down head movement.

[ April 29, 2003, 03:30 PM: Message edited by: Phalcon51 ]

Thanks Phalcon51! I will give that a try.