forums.naturalpoint.com

Hello pilots,

is somebody out there who can help me ?

Yesterday I got my trackIR (NaturalPoint) from the States.
After installing the software Version 2.01 / Restart /
plugin the USB-connector of the trackIR I can use the
trackIR with FB.

But I cannot setupp/configure the trackIR with the software.
Why?

The software-window pop up. But not in the whole range and size !!! It is cutted at the bottom and the rigth side !!

I see the men� only below to the line "run at setup" at the bottom and at the right side it ends with the words "create new" - I do not see and cannot use the close button at the bar at the right side.

I see only the whole men� in the mannual!!

I tried many several Screens from 640 up to 12.. /
I disconnect all USB-units / I installed the software
with Windows98SE and WindowsXP.......... (I use
physical HD-Mobile-Racks for the different systems).

I found no way to see and to use the whole men�.

This is a cry for help. I want to use my trackIR with FB !!

Thank you all for your answers.
I am from Munic / Bavaria / Germany and my foreign language
is not very good - please excuse me.

Viele Gr��e
Gerhard (Offline-Pilot-Opi)

You might want to check your font size settings in Windows. Try using the Windows default theme and see if that helps.

Good luck!

Hello pilots,
thank you all for your answers and your help.

Now it works properly !!

Teh problem was the font size - setting to
"small" and all works.

Thank you very much
Gerhard (offline-pilot-grandfather

You're quite welcome.