Obtaining raw values
Posted: Wed Mar 05, 2014 4:12 am
Hi, not sure if this is the correct board for developer questions, perhaps someone can move it if not?
I'm integrating the TrackIR5 into our simulation platform and trying to work out how to obtain the absolute position/orientation of the target.
No matter what values I send to NP_RequestData I always seem to get the same fields back in the TRACKIRDATA struct. Though I'm not sure if this would help if I can fix it as the 'Raw' value in TrackIR app isn't an absolute value, so I assume this is the same as would come back in the TRACKIRDATA struct?
Basically I just need the unadjusted 'default' position, rather than the offset version achieved when ReCenter is called.
Alternatively, ReCenter would be fine if I could load the centering info from a previous calibration, one when the tracker was in a fixed location.
Many thanks,
Ally
I'm integrating the TrackIR5 into our simulation platform and trying to work out how to obtain the absolute position/orientation of the target.
No matter what values I send to NP_RequestData I always seem to get the same fields back in the TRACKIRDATA struct. Though I'm not sure if this would help if I can fix it as the 'Raw' value in TrackIR app isn't an absolute value, so I assume this is the same as would come back in the TRACKIRDATA struct?
Basically I just need the unadjusted 'default' position, rather than the offset version achieved when ReCenter is called.
Alternatively, ReCenter would be fine if I could load the centering info from a previous calibration, one when the tracker was in a fixed location.
Many thanks,
Ally