forums.naturalpoint.com

Two things one on the new manual 2.00 at the top of page 22 it reads like this
c. Make sure the Motion Axis Lock is disabled (grey), and the X axis is selected (Blue)
d. Use the Speed slider to move the X axis edit point to 15.
e. Select the Y axis, and move the Speed slider to 10
f. Click the Enable Autopanning button
g. Move the Autopanning slider to 48

On my Naturalpoint program has no way to select x and y just has one Speed slider
x and y are grey out.how do I select them?!!

And two when I am in Quake 3 and trun to The right it trun around good but
when I trun to left it just stop how can I fix this?!!

thank's

Make sure CUSTOM is selected in the drop down box.

It is selected and when I move the speed bar both y & X move at same time. Now what can I try next
Thank's for trying to help

There is a little blue LINK icon between the X and Y. Un-highlight that and X should move independantly of Y.

quote: Originally posted by Tombstone7:
And two when I am in Quake 3 and trun to The right it trun around good but
when I trun to left it just stop how can I fix this?!!
Make sure that you're centered- it's very easy to get of center in Mouse Emulation mode. When in First Person Shooters, I always make sure that I have my Enable and Center keys right near my WASD keys to they're easy to hit. Any time motion starts to get 'off' (you'll get an intuitive sense for it pretty quick) just hit the Enable key, center your head, hit the Center key, and then the Enable key again.

It�s much easier and quicker than it sounds.