Page 1 of 1
Increasing Dead Zone
Posted: Sat May 09, 2015 8:24 am
by JimAllen
Trying to figure how to adjust the curve to increase the dead zone. I like the default profile but don't want to use the default hot keys. I've created my own profile and adjusted the curve to look like the default curve but my dead zone doesn't match the default.
What do I have to do to increase my dead zone?
Jim
Re: Increasing Dead Zone
Posted: Tue May 12, 2015 10:21 am
by Duke
Just move the dots horizontally out from center I would think.
Re: Increasing Dead Zone
Posted: Tue May 12, 2015 2:42 pm
by MikeWitham
JimAllen,
Duke is correct, you would move the second set of dots on your curve horizontally outward, but on the same level as your center dot.
You could also just load the default profile, and then click the copy button. It is the button that looks like two slips of paper between the template section and the add new profile button.
Regards,
Re: Increasing Dead Zone
Posted: Wed May 13, 2015 7:36 am
by JimAllen
Thanks for the advice. Greatly appreciated.
Jim
Re: Increasing Dead Zone
Posted: Wed May 13, 2015 4:55 pm
by MikeWitham
Jim,
Please let me know if that works out for you.
Regards,