Page 1 of 1
I can't do the characteriz.
Posted: Thu Nov 26, 2015 12:42 am
by Changwon
hi
I can't do the characteriz.
What 's the problem?
Motive 1.9.0 Beta 1
MotionBuilder 2015 SP1 64bit
OptiTrack_MotionBuilder_Plugin_3.0.0_Final_x64
Re: I can't do the characteriz.
Posted: Fri Nov 27, 2015 3:15 pm
by steven.andrews
Hello Changwon,
Could you please describe the problem you are having with the auto characterize?
I did notice that, if you select the character nodes that are created and open the Definition tab, the skeleton has been mapped but the Characterize check box has not been enabled. If you have the performers stand in a T-Pose facing positive Z, you can then enable the Characterize check box to finish characterizing.
I will be sharing this information with development as well, to be sure this is the workflow we intended, and not an oversight.
Best regards,
Steven
--
Steven Andrews
OptiTrack | Customer Support Engineer