Avoid movement when the head is slowing down
Posted: Sat Feb 03, 2018 4:41 pm
Hello,
I use trackir5 with a P3D airbus 320, so basically, a cockpit with a dense concentration of buttons and screens which are located further from the pilot than in a jetfighter.
Here is the problem: to reach the last switches on the upper overhead panel and pedestal panel I need to rotate my head a lot, making very difficult both to see and to stabilize the view (so almost impossible to clic on the smallest switches).
Yes I could lift the yaw and pitch curves in the software but I would result in a too sensitive tracking.
I'm looking for a solution to make the view completely stable when I try to stabilize my head.
So my question is: how to decrease the tracking sensitivity when the head is very slow.
I use trackir5 with a P3D airbus 320, so basically, a cockpit with a dense concentration of buttons and screens which are located further from the pilot than in a jetfighter.
Here is the problem: to reach the last switches on the upper overhead panel and pedestal panel I need to rotate my head a lot, making very difficult both to see and to stabilize the view (so almost impossible to clic on the smallest switches).
Yes I could lift the yaw and pitch curves in the software but I would result in a too sensitive tracking.
I'm looking for a solution to make the view completely stable when I try to stabilize my head.
So my question is: how to decrease the tracking sensitivity when the head is very slow.