Workflow with motive and flex13 cameras
Posted: Mon Jun 25, 2018 11:41 pm
Hi all,
I am using Motive with some flex13 cameras via 2 synced optihubs. Everything is working great, but there are some things I am not sure about:
- In order to turn off the cameras I have to close Motive. If I close Motive I find sometimes I need to re-calibrate it when I open it again. Do I need to close Motive? Do the cameras need to be turned off or is it ok to leave them on for extended periods of times (days, weeks, or even months)?
- After closing Motive and unplugging and re-plugging the USB for the optihub from the PC I find I also need to re-calibrate. I can still see the markers fine in the 2d view of each camera, but the 3d view only recognizes 3/6 of my markers. Usually when only closing and opening Motive, or even rebooting the PC, I don't have this problem. Does disconnecting the optihub USB and reconnecting force re-calibration?
I guess my general question is how the workflow with Motive and and flex13 cameras via optihub should be done in order to not need to re-calibrate. When do I need to close Motive and turn off the cameras and how will doing so affect my calibration?
Thanks in advance for any help available,
Or
I am using Motive with some flex13 cameras via 2 synced optihubs. Everything is working great, but there are some things I am not sure about:
- In order to turn off the cameras I have to close Motive. If I close Motive I find sometimes I need to re-calibrate it when I open it again. Do I need to close Motive? Do the cameras need to be turned off or is it ok to leave them on for extended periods of times (days, weeks, or even months)?
- After closing Motive and unplugging and re-plugging the USB for the optihub from the PC I find I also need to re-calibrate. I can still see the markers fine in the 2d view of each camera, but the 3d view only recognizes 3/6 of my markers. Usually when only closing and opening Motive, or even rebooting the PC, I don't have this problem. Does disconnecting the optihub USB and reconnecting force re-calibration?
I guess my general question is how the workflow with Motive and and flex13 cameras via optihub should be done in order to not need to re-calibrate. When do I need to close Motive and turn off the cameras and how will doing so affect my calibration?
Thanks in advance for any help available,
Or