Cameras and OptiHub 2.0 restarting

Post Reply
blessonremo
Posts: 2
Joined: Wed Oct 03, 2018 11:25 pm

Cameras and OptiHub 2.0 restarting

Post by blessonremo » Wed Oct 03, 2018 11:57 pm

I am having a problem getting the following setup to work:
12 Flex13, each 6 are connected to an Optihub v2, the 2 hubs( Master, slave) connected via a sync cable, one hub's uplink is connected with the pc with an extension cable (from naturalpoint)

The first problem was that the naturalpoint adapter stopped working( 0v recorded in output - root cause still not found).

Then we tried using adapters from local vendors from similar configuration( 12v 4A) . And OptiHub started restarting with the new local adapter, If we remove one camera , then the OptiHub doesnt restart instantly , but restarts after 20-30 mins.

If we try to work with 5 cameras then after sometime we get the error " not receiving frame data"

We have ordered 2 Optihubs , but would like to know the root cause of this inconsistent behaviour.

steven.andrews
NaturalPoint Employee
NaturalPoint Employee
Posts: 470
Joined: Mon Jan 19, 2015 11:52 am

Re: Cameras and OptiHub 2.0 restarting

Post by steven.andrews » Thu Oct 04, 2018 7:38 am

Hello blessonremo,

Thank you for reaching out to the community regarding your connection issues.

An issue such as this can be hard to diagnose without walking through the entire configuration. If there was a power adapter failure, perhaps this could have affected the OptiHubs, but it is hard to say without testing a new OptiHub and adapter provided by us.

I see you have a remote session scheduled with one of our engineers soon. Please feel free to mention these issues in that session so you can troubleshoot together and, hopefully, determine a cause.

Best,
Steven
--
Steven Andrews
OptiTrack | Senior Customer Support Engineer
help.naturalpoint.com
support@optitrack.com

Post Reply