Page 1 of 1

Motive 1.7.3 calibration crash

Posted: Thu Jun 04, 2020 2:42 am
by mspedden
Hello! I am trying to run Motive 1.7.3 (our license is a few years old) on a new computer (Lenovo ThinkPad Yoga 4) running Windows 10. When I try to perform a calibration, Motive crashes and shuts down. This is a computer specific problem because the exact same setup works on my older Dell computer.
I open Motive, adjust camera settings, and click 'Start Wanding' - then Motive just shuts down.
Any suggestions as to how to troubleshoot this would be greatly appreciated.
Thanks
Meaghan

Re: Motive 1.7.3 calibration crash

Posted: Thu Jun 04, 2020 5:28 pm
by Pixerati
My guess would be that you're missing one of the Windows frameworks that doesn't get called until calibration. At least that's what I'd check first. Sometimes a framework can get skipped during install if your system already claims to have it...