Page 1 of 1
Non-symmetric response curve
Posted: Mon Feb 16, 2004 5:54 pm
by fever
Is it possible to have a non-symmetric response curve for the X tracking axis? I'd like to make the left side more responsive than the right (reflective dot on the headset mic doesnt behave like a reflective dot on the center of a hat).
Re: Non-symmetric response curve
Posted: Thu Feb 19, 2004 2:34 am
by Donald
Go to the "Motion" screen. Right above the Speed slider there is an "Edit Motion Axis" setting. Click the chain link to disconnect the X & Y axis lock. Now you can adjust the X & Y axis separately.
Please see section 4.1.3 on pages 13 & 14 in the manual for more detail.
Re: Non-symmetric response curve
Posted: Thu Feb 19, 2004 3:11 am
by fever
I understand that but that is not what my question refers too. I want to adjust left and right response independent from one another on the same axis. Right now its symmetric.
Re: Non-symmetric response curve
Posted: Thu Feb 19, 2004 5:49 pm
by Donald
Ahhh---my bad.
Unfortunately the software will not allow this type of configuration at this time.